Bike7 - Hand Soap Pro Gel Jar 4L

This hand soap quickly removes the most stubborn contaminants without irritating the skin. Its soft natural granules ensure pore-deep action while respecting the skin. Moreover, those granules are biodegradable and do not contribute to the formation of microplastics. Concentrated formula, economical to use. - Quickly removes grease, glue, resin, silicone and tar.- Skin-friendly formula with natural scrubbing agent.- Also for use without water. - Form: gel.- Colour: yellow.- Odour: lemon.- Density (at 20°C): 0.99 g/cm³.- Solubility in water: emulsifies.- pH value: 6.- Viscosity (at 20°C): 175000 mPa*s.- Shelf life: 12 months, in closed packaging, kept cool and frost-free.

Solvent-free wax emulsion for optimal chain lubrication, precise shifting and noiseless transmission. Easy longterm maintenance. Apply to clean, dry chain. Clean if necessary with Degrease and Clean, rinse and dry. Apply two layers of Pro Wax to the inside of the entire chain, leaving 3 hours between applications. Maintenance: wipe the chain with a cloth, apply a layer of Pro Wax and allow to dry. After 600 km: see point 1. Drying time depends on ambient temperature and air humidity.

Pro Seal is a latex emulsion that quickly seals holes in all tubeless tires, whether mountain bike or racing tires. Pro Seal is applied through the valve or poured directly into the partially disassembled tire and provides effective immediate repair. Can be used in both "Tubeless" and "Tubeless ready" tires. Closes holes up to 8mm. Compatible with CO2 cartridges. Contains natural Latex, is not corrosive or toxic. Pressure resistant up to 7 bar / 100 PSI. INSTRUCTIONS: Disassembled tire: New tire: clean the inside with Bike7 Degrease and wipe. Install one side of the tire and keep the wheel straight. Shake the bottle vigorously and pour the required amount directly into the tire, keeping the bottle upright. Assemble the tire completely. Mounted tire, with the 125 ml bottle: Remove the valve core and place the wheel, valve down, vertically without pressing the rim against the ground. Shake the bottle vigorously, cut the spout 2mm from the end and pour the required amount directly through the valve while keeping the bottle upright. Reassemble the valve. Inflate the tire: Gently turn the wheel one full turn. Inflate the tire until it fits properly. Turn and wiggle the wheel for ± 1 minute for a good distribution of the Bike7 Pro Seal. Adjust the tire to the desired pressure. Road tire (23-30 mm): 60 ml / tire and MTB tire (29 ", 2.0-2.4): 100 ml / tire. A larger amount is recommended for larger tires. A larger amount of product can be used for better protection. Effective life between 3 and 8 months, depending on the circumstances. Check the fluidity of the product every month and top it up if necessary.

Degrease is a fast acting, thorough and safe in-depth degreaser for all mechanical bicycle parts and all surfaces. Degrease removes oil, grease, tar and adhesive residues without damaging the substrate. At the same time, Degrease is safe to use on all bicycle components. It removes all kinds of oil, grease, wax, adhesive and tar residues from the bicycle frame and all moving parts. Fast and in-depth degreasing of disc and drum brakes, gear switch, bracket, front and rear derailleurs, sprocket wheel, ball head, etc. Removal of old lubricants from bearings. Removal of adhesive residues. Removal of tar and grease spatter (frame, tyres, ...). Removal of oil, silicone, wax, tar, asphalt, adhesive resisdues, etc. from stainless steel, aluminium, paint, rubber, carbon, textile, and so on. Removal of 'grease stains' on matte finish bicycle frame. Removal of all Bike7 products: Lubricate, ... . Give the product 3 minutes to work its way in before applying a lubricant. Brake disks should be blown dry before cleaning. Lubricate all moving parts with Lubricate for optimal maintenance.